Microscopic uniformity in plasma etching

Gottscho, Richard A.; Jurgensen, C. W.; Vitkavage, D. J.

doi:doi:10.1116/1.586180

Volume/Page
Keyword
DOI
Citation
Advanced

Volume: Page/Article:

Search Content Type

article doi:

Citation:

You are not logged in to this journal. Log In

Journal of Vacuum Science & Technology B / Volume 10 / Issue 5

Previous Article | Next Article

J. Vac. Sci. Technol. B 10, 2133 (1992); http://dx.doi.org/10.1116/1.586180 (15 pages)

Microscopic uniformity in plasma etching

Richard A. Gottscho¹, C. W. Jurgensen¹, and D. J. Vitkavage²

¹AT&T Bell Laboratories, Murray Hill, New Jersey 07974
²AT&T Bell Laboratories, Allentown, Pennsylvania 18101

Abstract

Citing Articles (168)

Alerts
- Alert Me When Cited
- Alert Me When Corrected
Tools
Share
- Email Abstract
- Connotea
- CiteULike
- del.icio.us
- BibSonomy
- Tweet this Article
- Add to Facebook

Full Text: Download PDF | Rent Article | Buy PDF (US$28) | View Cart

As we enter the era of ultra‐large‐scale integrated circuit manufacture, plasma etching grows more important for fabricating structures with unprecedented dimensions. For feature sizes below 1 μm and aspect ratios (depth/width) much larger than one, etching rates have been observed to depend on aspect ratio and pattern density. Such dependencies tend to increase the cost of manufacturing because even small changes in device design rules, cell design, or wafer layout can result in time‐consuming, new plasma process development. In addition, microscopically nonuniform etching affects the trade‐off between chips lost from failure to clear and chips lost by damage from overetching. Although aspect ratio and pattern dependent etching have been observed for a large variety of material systems and processing conditions, the fundamental causes underlying these effects are poorly understood. Partly, this results from use of confusing and conflicting nomenclature and a lack of careful, quantitative comparisons between experiment and theory. In this article we review recent literature on microscopic uniformity in plasma etching and carefully define terminology to distinguish between aspect ratio dependent etching (ARDE) and the pattern dependent effect known as microloading. For ARDE, we use dimensional analysis to narrow the range of proposed mechanisms to four which involve ion transport, neutral transport, and surface charging. For microloading, we show that it is formally equivalent to the usual loading effect, where the reactant concentration is depeleted as a result of an excessive substrate load.